Open-plan kitchen with a white waterfall island facing the dining and living areas
Bülent May 04, 2026

Open-Concept Kitchen Planning: What to Consider Before Changing Your Layout

Before you turn a closed kitchen into an open-concept kitchen, find out what the wall is doing and what leaves with it. If the wall carries load, the job needs an engineer or architect and a construction permit. Even when it carries nothing, it probably holds wall cabinets, a hood duct, wiring or plumbing, and it is the one thing keeping cooking noise and a sink full of dishes out of the living room. Plan a replacement for each of those first, then decide how much wall to take down.

Start with what is inside the wall

You cannot tell reliably from the kitchen side whether a wall is load-bearing. A licensed engineer or architect makes that call, and if the wall does carry load, the same professional specifies the beam and the posts that replace it. Treat a contractor who offers to remove the wall without that step as a warning sign.

In New Jersey the permit question is settled by the Uniform Construction Code. The state's Department of Community Affairs says a construction permit is required for work on existing buildings that includes structural, plumbing, mechanical or electrical work, and the code's list of permit-free ordinary maintenance specifically excludes cutting away any load-bearing wall or partition. Your municipal construction office issues the permit and inspects the work. Our guide to kitchen remodel permits in New Jersey covers the process.

Structure is only the first thing to look for. Interior kitchen walls often hide a plumbing vent, supply lines to an upstairs bath, a heating duct or the circuit that feeds half the room. Each one can be rerouted by the right licensed trade, and each one adds work that has to be drawn and inspected before the wall opening is closed up.

A note on roles: Aqua Kitchen designs the layout and supplies and installs the cabinets and countertops. Structural work, and the plumbing and electrical changes that go with it, belong to your general contractor and licensed trades.

What you give up when the wall comes down

Wall cabinet storage

A wall that holds upper cabinets is holding dishes and dry goods that will need a new home. Measure the run of wall cabinets you would lose and decide where that volume goes before demolition. The usual answers are a tall pantry cabinet on a remaining wall, deeper drawers in the island or peninsula, and wall cabinets that run to the ceiling elsewhere. The guide to pantry cabinet options shows how much a single tall unit can absorb.

A wall for the range and its hood

If the range sits on the wall you plan to remove, it has to move to another wall or into the island, and the hood duct goes with it. The NKBA Kitchen Planning Guidelines recommend a correctly sized, ducted ventilation system for every cooking surface, with 150 cubic feet per minute as the recommended minimum. In an open plan that matters more, because there is no doorway left to contain smoke and grease. An island hood needs a duct route through the ceiling framing, and a powerful hood can trigger a makeup-air requirement under the mechanical code, so have the HVAC contractor and the local code official weigh in before you pick the appliance.

Quiet

The dishwasher, the disposal, the hood fan and the refrigerator compressor will share a room with the television. Appliance specification sheets list sound ratings in decibels. Compare them when you shop, and give that number more weight than you would for a kitchen with a door.

A hidden work area

From the sofa, and often from the front door, people will see the sink, the counters and whatever is on them. Three layout choices reduce that. Keep the main sink on a perimeter wall and leave the island clear. Add a raised ledge on the living-room side of a peninsula, since a 42-inch-high counter, one of the three seating heights in the NKBA guidelines, screens a standard-height work surface behind it. Or give small appliances a closed home in a pantry or an appliance cabinet. For more layout ideas, see our renovation ideas by kitchen style.

A continuous floor

Where the wall stood there is no finished floor, and the two rooms may have different flooring at different heights. A patch in an existing floor is hard to hide, so plan for the possibility of new flooring across both rooms. That raises the question of whether flooring goes in before the cabinets, which should be answered before either is ordered.

Full opening, partial opening or peninsula

Taking the whole wall out is one of three options, and the other two avoid some of the losses listed above.

Option What stays Best when
Remove the wall, add an island Nothing, apart from a beam if the wall carried load The combined room is wide enough for aisles all around the island
Peninsula on the old wall line Base cabinets and counter where the wall stood The room is too narrow for an island, or you want a boundary with seating
Wider doorway or pass-through Part of the wall and some wall cabinets The wall holds structure or utilities that are costly to move

The island option depends on floor space. The NKBA recommends a work aisle of at least 42 inches for one cook, measured between counter fronts, and an island needs that on every side where someone works. Run the numbers in our guide to how much room an island needs before assuming the opened room can hold one.

A kitchen peninsula keeps one end attached to the remaining cabinets, so it needs one aisle fewer. It also keeps a line between kitchen and living space, gives you base cabinet storage on the old wall line and can carry stools on the far side. The trade-off is a single entry into the cooking area.

A partial opening keeps the most storage and usually needs the least structural work, although a wider opening in a load-bearing wall still needs a header sized by the engineer. It suits a house where you mainly want daylight and conversation to pass between the rooms, and where the wall cabinets on either side of the opening are doing a job you would struggle to replace.

An order of work that avoids backtracking

  1. Have an engineer or architect confirm what the wall carries and draw the structural fix, including where any post or dropped beam will land.
  2. Design the new kitchen for the opened room at the same time. A post at the end of a peninsula or a beam that drops below the ceiling changes cabinet sizes, so the two drawings have to agree.
  3. Apply for the construction permit through your contractor or the municipal construction office.
  4. Complete demolition, framing, and rough plumbing, electrical and duct work, with the inspections each requires.
  5. Close the walls and ceiling and finish the floor as planned.
  6. Install the cabinets. The countertop template comes after the cabinets are set and level, because the stone is cut to the cabinets as built.

For where these steps sit in a full project, see the steps to remodel a kitchen.

See the opened room before demolition

The cheapest time to compare a full opening with a peninsula is while both are still drawings. Our free 3D design service is suited to that comparison. After measuring the space, a designer builds the layout as a 3D model and revises it with you, so you can ask to see each version from the living-room side and count the storage in each. Bring the engineer's sketch if you have one, so posts and beams can be included in the model. Because the cabinets will be on view from the next room, it is also worth looking through the door styles and finishes in our kitchen cabinet collection early.

Share